If you use a coarse top conveyor peelers before metering conveyor to a suitable size, slashing the rough surface. Xiao Bian found that many people use the deduction is not very accurate, detailed overview of the following:
1, if applicable, will be demolished and rims outsourcing card into the card from the hook hook retainer. Use wear off fixed hook. Description: Only when transporting the bandwidth needed to use the other two joined in when extra deep slot fastener. Do not connect the hook into the slot. When the delivery of bandwidth when operating in bonding clamp see subsequent instructions.
2, when the conveyor belt buckle into the bonding clamp and ensure that it fully into the pliers. It is centered. Bonding clamp jaws closed until near the hook.
3, if cardstock cover hook, in line with the pre-cleared. If cardstock cover fasteners hook area, after clearing of the lacing.
4, the hook is inserted between the conveyor belt. Placed on the conveyor belt hook holder stable, to engage better, we recommend the conveyor belt toward the bottom plate.
5, as closely as possible to embed the hook clamp close engagement.
6, the release of pressure bonding clamp and slide plate attached to the buckle end.
7, once again joining clamp tightly closed. This will engage all the forces applied to the clamp and properly nailed hooks within 1 inch of the area.
8, the operation is repeated over the entire bandwidth (Step 6 and 7), once one inch in mind.
The above is a brief overview of the use of the deduction deduction conveyor operating instructions, hoping to be helpful.