When long-distance conveyor scratch phenomenon occurs when, with patches of cold curing adhesive patch with the most convenient and effective method , the following

I will briefly summarize the method of use of the patch

      1 requires the use of professional angle grinder grinding paste repair of the place, with German imports of tungsten steel grinding disc, ( the best selection of high-power angle grinder

Low angle grinder, angle grinder recommended L1202 ) polish on the wound site until the injury site surface appears rough surface .

      2 The polished surface clean, (recommended Dipu Te imported detergent ) and then brushing cold curing adhesive , let it dry to slightly tacky

But does not adhere to paint the second time in the dorsal . And repair of the above brushing cold vulcanizing glue, rubber damaged if the wound site is too large , you should use the first

Fill.

      3 When the second layer slightly dried paste it time to start bonding process to avoid packet into the air , and then use the compaction roller from the inside

Rolling patch to the outside , which was compacted and discharged bubbles.

     Zhengzhou Dipu Te providing repair of imported , with its simple , fast and convenient method is to use a number of mines, docks , power plants

, Plants use , will reduce downtime to a minimum level , the majority of users.