Some conveyor belt storage and use precautions, and I hope to help some friends using the conveyor belt :
   Conveyor in transport and storage , should be kept clean to avoid direct sunlight, rain and snow Baptist leaching , preventing substance in contact with acids, alkalis, oils, organic solvents affect the quality of the rubber , and one meter distance outside heating devices.
   Storage warehouse when the temperature should be maintained at between -15 ℃ to +40 ℃, relative humidity should be maintained between 50-80 %.
   Stored in a roll conveyor shall be placed not folded , storage time should be turned over once each quarter .
   Conveyor speed of not greater than 0.5 meters a second, transport block degree , wear resistance of materials should be used with a large pear -shaped discharge fixed and maximize the use of low-speed devices . When the tape exceeds a predetermined speed , will affect the life of the tape .
  Complementary relationship conveyors and conveyor drive roller diameter fabric layer drive roller and the idler pulley and the idler groove angle requirements , the design should be based on the provisions of the conveyor , a reasonable choice .
  To mitigate the impact of the tape material and wear , you should run along the direction of the tape feeding direction ; materials falling into the gap between the tape shawo should be reduced as much as possible within ; mouth should avoid feeding rollers or just above the idlers ; tape section should be shortened by feeding roller spacing and buffering measures taken . To prevent the scratch tape, stop feeding device , the blade cleaning means and a discharge means in the contact portion of the tape take appropriate hardness of the rubber sheet , do not use the first fabric layer is interposed on the tape .
   Conveyor belts in use should note the following:
     A, to avoid the roller is covered with the material , resulting in ineffective rotation to prevent leakage of material between the rollers and tape the card to avoid moving parts lubricated , but not oil conveyor belt.
    B, seeks to avoid starting with a load .
    C, deviation occurs when the tape should take timely corrective measures .
    D, local damage occurred tape should be promptly repaired to avoid expanding.
    E, to avoid arrest suffered tape racks , pillar or bulk materials , to prevent tearing Pengpo .