No matter what , after using for a long time there will always be above the rift , the conveyor belt is also true, but how can we better use of the conveyor belt to reduce scratching happen ? Together look down:

In the row of glue temperature control on the principle of the need to maintain a certain amount and nature of improvement. Encountered in the conveyor belt under more environmental improvement , during transmission, you can add some amount of suitable mixing substances to prevent early burn rubber and strengthen the rolling process control , in dealing with the protection of fire-retardant conveyor belt in turn effectively removed scar.

Adjust the belt cover rubber formula, making more use of the time , always have a scar above the conveyor belt will affect the appearance, even when not using for a long time after treatment , crack and so the situation can also occur in a timely manner the processing becomes critical . Conveyor often carrying a lot of real life, in a good treatment process , the thickness of the film can protect the conveyor line , smooth, has a high aesthetic factors at the same time , also to enhance the advantages of more practical use . Above the conveyor belt can achieve better adhesion with dosage reduction in the effective prevention of chapped , but also improves the flow properties of rubber .

Conveyor to our lives has brought a lot of convenience and security. After the use of timely maintenance , is the security of a more permanent factor.

How retardant conveyor maintenance

Retardant conveyor belt is impregnated with PVC dipped into a paste made ​​of plastics or vulcanized , so this belt has high strength, large volume, transport balance characteristics. If you want to always maintain the normal use of conveyor belt , it is necessary to carry out maintenance , then to how retardant conveyor belt is properly maintained it ?

First, the conveyor in the transport and storage , must be kept clean and free from sun exposure and wet snow , but also avoid affecting the quality of rubber acid , oil contacts should be placed at a place away from the heat means one meter away . Second, the maximum storage temperature must not exceed 40 degrees minimum can not be below minus 15 °, and the humidity should be maintained between 50-80% . Thirdly, placed in storage can not be folded and turned over once in each quarter . Fourth , the conveyor belt at work running speed is not greater than 5 meters per second , like some large blocks , wear big to be used when the material in the transport speed . Fifth, the direction of the feed must be consistent with the tape running direction in order to avoid the impact of material on the tape and wear too much , making the belt life cut short . Sixth, we must choose according to the design of the conveyor drive pulley diameter suitable belt fabric layer relationships and supporting rollers bend pulley and idler groove angle on the requirements .

This is more than six o'clock in the storage and use of conveyor belts should be noted that several points , in order to make the conveyor belt can extend the life of normal use and should pay special attention to these places.