FAVORITES
FEEDBACK
SITEMAP
| How to solve the problem of PVC conveyor belt slippage | |||
| Author:admin Source:Original Updated:2013-8-7 | |||
Conveyor belt during use, will inevitably encounter or that problem, conveyor often encounter slippery conditions, strong belt factory today to teach you how to deal with this question:
A, PVC conveyor load is too large, more than the motor capacity will slip. At this point the positive side slip of the motor plays a protective role. Or a long time the motor will burn out. But for running it is slipping accidents. Second, start too fast can also form slipping. This time can be slow to start. Such as the use squirrel cage motor, jog twice before starting, but also can effectively overcome skidding. Third, do not turn tail pulley bearing damage or up and down roller bearing damage does not turn too much. Cause of the damage is the tail drifting too much, did not timely repair and replacement of damaged parts or rotation is not flexible, so that resistance increases caused by skidding. Fourth, the drive pulley and the belt is not caused by the friction between the skid. Its not the most likely cause is the conveyor belt of water or humid environment. The solution is to add some rosin on the drum end. But be careful not to hand dosing, and the application blast blowing equipment to avoid personal injury. Fifth, the initial tension is too small. PVC conveyor belt tension at the drum enough to leave cause slippage. This situation generally occurs during startup, the solution is to adjust the tensioning device, increase the initial tension. | |||
|
