Steel Conveyor rubber surface is damaged, usually as long as the damaged areas cleaned polished painted mortar, and then covered with plastic cover can be cured. There are two ways specific repair patch with heat curing cold glue.

Cold and heat curing adhesive patch repair method of operation is basically the same, mainly in the following steps:
a cleaning tape surface, wipe clean, repair parts to draw with chalk, draw and cut into round, diamond or rectangular, square angled to reduce the fill pad delamination;
b stripped and damaged plastic cover core fabric layers until the undamaged core and made ​​into a stepped incision.
c then form a relatively smooth polished and rough machined surface, coating layered supplement repair material slurry, which requires connection with the adhesive tape is basically the same.
 
If a damaged wire rope conveyor exposed, they need to respect the damage to dig up all the glue and rubber core, and were inserted in the core gum and gum surfaces. And pay attention to all sections of the plastic material must be wedge shaped and polished to cleaning. For already rusty wire, generally need to be cleaned rusty steel parts.