FAVORITES
FEEDBACK
SITEMAP
| why sidewall conveyor can not stick inclined | |||
| Author:admin Source:Original Updated:2013-7-22 | |||
Summer heat wave in the use of inclined conveyor belt adhesive bonding, especially when using the flame retardant adhesive bonding in the summer, often appear so kind of phenomenon: obviously we feel that the surface layer has dried, but after fitting easily fit peeling, and touch the adhesive surface layer with adhesive also form a "former dry wet" phenomenon, resulting not stick or stick is not strong. This phenomenon is quite annoying.
Following on from ZhongBo Industry and Mining Machinery Co.,Ltd to explain why sidewall conveyor can not stick inclined . Comprehensive analysis of the following reasons: This is due to high summer temperatures, the adhesive solvent evaporation faster than the autumn and winter, and we polished off the conveyor belt adhesive surface gluing, the part of the glue would like to penetrate inside the conveyor belt to form like riveting riveting same point, this part of the glue surface area of the volatile solvent evaporation is slower in high temperature environments are often fast drying surface is dry enough, but there has not yet sufficiently volatile solvent, then the connector fitting after solvent which will evaporate slowly, over a certain time wetting the adhesive layer, the adhesive surface damage, affect the bonding effect. Excessive evaporation caused bond is not strong. The solution to this problem, we are required to bond rubber belt when the first pass of the brush, to ensure adequate air time or baking, to ensure penetration of the glue into the belt sufficiently volatile solvent, to form a stable viscosity Sockets Layer. | |||
|
