Round pit is one of the most commonly used prevent slippery conveyor belt, conveyor belt round pit pattern friction coefficient is big, increase resistance, prevent slipping.
Round pit conveyor belt is introduced:
Round pit type herringbone type (V) round pit pattern, friction coefficient, increase resistance to prevent slipping. Round pit conveyor belt is suitable for conveying grain size under 50 mm coal, gravel, sand, grain and soft bag packaging, the largest Angle can reach 30 degrees. Herringbone pattern Angle the tip on the center line to make the material packed into the central part of the handle.
Round pit pattern, friction coefficient, increase resistance to prevent slipping.
Round pit conveyor belt is suitable for conveying grain size under 50 mm coal, gravel, sand, grain and soft bag packaging, the largest Angle can reach 30 degrees. Round pit type herringbone type (V) round pit pattern, friction coefficient, increase resistance to prevent slipping. Herringbone pattern Angle the tip on the center line to make the material packed into the central part of the handle.
Non-slip belt maintenance methods:
Non-slip belt in transportation and storage, should keep clean and avoid direct sunlight or snow and rain leaching leaching, prevent from acid, alkali, oil, organic solvents, such as physical contact, and distance is one meter outside heating device.
Storage at the warehouse temperature should be kept between 18 to 40 ℃, relative humidity should be kept between 50-80%.
During the period of storage, conveyor belt must be placed in rolls, not folding, during the placement should be turning a quarterly.
Different types, specifications and the layer number of conveyor belt should not be used together, the best joint connection with glue.
Conveyor belt type, structure, specifications, conditions of layers should be used according to the reasonable choice.
Conveyor belt running speed should not be commonly more than 2.5 m/s, large blocks, abrasion resistant material and use fixed discharging device should be adopted as far as possible low speed.
Conveyor drive roller, drive roller and the relationship between conveyor belt layers and the diameter, the redirection roller and the supporting roller groove Angle requirements shall be according to the regulations of the design of the conveyor, reasonable selection.
Feeding direction should be along the conveyor belt running direction, to reduce the material down the impact on the conveyor belt shall adopt when chute, reduce material falling distance; Conveyor belt material section should be shortened, impact idler roller spacing and used for the leak, take to use soft moderate keep-off board, lest gear plate quality, scraping the broken belt of the belt surface.