ZhongBo Industry and Mining Machinery Co.,Ltd is mainly engaged in the r&d, manufacturing and sales. Leading products are common, heat-resistant (high temperature), acid and alkali resistant, oil resistant, cold resistant, wear resistant, different properties such as general flame retardant cotton canvas (CC), nylon (NN) conveyor belt, polyester (EP) flat and large dip Angle gear sideband, with decorative pattern, such as conveyor belt.
Conveyor belt is the key to the conveying system equipment, it directly influences the safe and stable operation of the production operation. Conveyor belt running deviation is the most common fault of belt conveyer, the phenomenon and reason of a lot, according to the different running deviation phenomenon and reasons of the different adjustment methods, can effectively solve the problem, to the timely and accurate processing is the guarantee of the safe and stable operation.
Head or tail driving drum redirection roller's axis is not perpendicular with the center line of the conveyor, conveyor belt roller of the head or the tail redirection roller from wandering. Platen deflection, firmness, on either side of the conveyor belt on the drum along the width direction of the traction Fq also inconsistent, as increasing or decreasing trend, for the head to the right side of the drum drum, such as conveyor belt running deviation, the bearing should move forward, on the right side of the conveyor belt to the drum of the left side of the wandering, is on the left side of the bearing should be move forward, the corresponding also can be on the left side of the bearing seat back or right side of the bearing seat. Roller surface processing error, sticky material or wear caused by uneven diameter sizes, on one side of the conveyor belt to the larger diameter, wandering, we are going to clean up roller surface sticky material and machining errors and uneven wear has to be replaced down reprocessed plastic bags processing, installation of self-aligning roller, self-aligning roller there are different types of groups such as the middle shaft type, four connecting rod type, use blocking or roller rotation in the horizontal plane directions or lateral force make the belt automatically to achieve the purpose of running deviation of the belt can be adjusted, in general is relatively short or the total length of a belt conveyor belt conveyor two-way runtime USES this method is reasonable, reason is the short belt conveyor is easier to adjust. And it is not easy to Had better not use this method and long belt conveyor, because use of self-aligning roller group will produce certain effect on the service life of the conveyor belt.