Caesar feed belt conveyor is a common problem , the reasons are multi-faceted . But the focus is to strengthen the routine care and maintenance .

1 point spread material reproduced reprinted material at the point spread mainly in the fall hoppers, chutes , etc. . If severe overload belt conveyors , belt conveyor chute gauge rubber apron damaged chute plate design at distant long rubber apron so that the material out of the chute from the belt . The above situation can be in control of the transport capacity , strengthen the maintenance to be resolved on maintenance.

2 Caesar feed concave section concave section belt vacant belt when the interval when the concave radius of curvature smaller segment will generate vacant belt , then the belt into the groove circumstances change , because the belt has left the trough idlers , general groove angle becomes smaller, so that part of the material spread out . Therefore , at the design stage should be possible to use a larger radius of curvature of the concave section to prevent the occurrence of such situations. As the mobile mechanical loading machine , stacker-reclaimer machines and equipment in order to shorten the trailer will be designed into a non- circular concave section where the transition period , when the belt width is smaller redundancy selection easier to spread the material .

3 material spreading spreading material of the belt when the deviation when the deviation is due to the two edges of the belt runs the height changes , the high side and the other side is low, the spreading material from the lower side , the processing method is to adjust belt deviation.