For us to do day rubber conveyor belt inspection, weekly inspection , monthly inspection , etc., of course, rubber conveyor belt inspection should involve different parts , here we come to explain in detail the problem of rubber conveyor belt carrying overhaul point .

Rubber conveyor belt bearing point : Point conveyor belt carrying fragile site. Belt speed is an important factor as well as the particle size of the material conveyor run impact and load running direction attention. Blanking chute opening width of the receiving end should be large enough .

Loaded on the conveyor belt running direction at an angle point only exacerbate wear rubber tape material surface . Material impact on the rubber tape , feeding off-center , makes rubber tape along the roller rotates while climbing to the other side of the deviation will result in damage to the rubber tape , increasing local surface adhesive wear.

Heavy, sharp edges and corners of the material , or have some impact on the fast-running slide rubber tape, also scratched and worn surfaces. General method of reducing this wear is placed on the rubber tape first powdery material , followed by the bulk material is loaded , so the powder material plays the role of a cushion to protect the rubber tape.

In the drop chute set at a certain distance of the screen , fine materials through the sieve of the gap formed first fell on a cushion rubber tape, bulk materials after screening deceleration slowly fall to the mat , thus reducing a material impact on the rubber tape .