The following are several examples of the conveyor belt joint is not strong questions:
    Plastic surface contamination , loss of activity, causing insufficient adhesive strength . , The joint detachment ; adhesive is incorrect, insufficient weight on the side seam glue is not sufficient , the joint can not stick ; if no joints after bonding edge joints for hammering , pressing, is glued joints better together , will result in insecure ; adhesive immediately after use , did not give sufficient standing joint curing time , resulting in joint fracture ; unused I glue affected by the environmental impact will gradually solidified viscous , which will lose their sticky , if it continues to use , painted at the seams , it will destroy the original tack adhesive strength ; after the glue did not fully dry glue to stick the hand , causing gum inside the solvent evaporation is not fully used ; when bits are not binding right , leaving the adhesive surface of the air ; coating thickness uniform, thin layer first dry , thick places volatile solvent is not finished , there is no initial adhesive strength , resulting in a virtual sticky ; bonded hammering when the exhaust air is not evenly. These will cause belt joints are not strong, so when they do joints carefully and choose the advanced technology and skillful master to operate. Baoding strength conveyor belt factory has advanced technical support , production equipment and experienced technicians, customers are welcome to visit and order.