We want to do for rubber conveyor belt daily inspection , weekly inspection, monthly inspection and so on, of course, rubber conveyor belt inspection should involve different parts, here we come to explain in detail overhaul of rubber conveyor belt carrying point problem .

Rubber conveyor belt bearing points : points conveyor belt carrying fragile parts . Conveyor belt speed and running on particle size , impact and direction of operation are hosting an important factor attention . Blanking mouth width guide trough the receiving end should be large enough .

Angle point in the conveyor belt running direction will only exacerbate the rubber material loaded on the tape surface wear. Material impact on the rubber tape , off-center feeding, make rubber tape along the roller rotates while climbing to the other side of the deviation will result in damage to the rubber tape , adhesive wear increased local surface .

Heavy, sharp edges and corners of the material in the rubber tape running quickly produce a certain impact or sliding , also scratched and worn surfaces. The general approach to reduce such wear , the first powder material placed on the rubber tape, followed by loading bulk materials , so that the powder material plays a role of a cushion , thereby protecting the rubber tape.

In the drop chute set at a certain pitch sieve , fine materials through the sieve of the first fall rubber tape gap to form a cushion, bulk materials through screening deceleration after slowly falling the cushion , thus reducing a material impact on the rubber tape .