ZhongBo Industry and Mining Machinery Co.,Ltd mainly engaged in R & D, manufacturing and sales. The main products are ordinary, heat (temperature), acid, oil, cold, abrasion, flame and other general performance of different cotton canvas (CC), Nylon (NN), polyester (EP) conveyor belt and other flat and large inclination files sideband tread belt, other special-shaped conveyor belt. And a roller, roller, frame, electric roller conveyors such ancillary products, heat-resistant conveyor belt, canvas belt and rubber conveyor belt. Drive pulley; bend pulley; electric drum; magnetic pulley (magnetic drum); Care roll; stent; lug; tensioner; sweepers; couplings TD75 transportation machinery and ancillary products more than 200 kinds. Currently, Botswana Mining Machinery Co., Ltd. has become the largest conveyor belt manufacturer in Hebei Province.

      Here to tell you about steel cord conveyor belt curing joint approach.

   Joint production of steel cord conveyor belt mesh each lead all cut and scrape the surface of the attached plastic, the steel cord conveyor belt wire roots labeled with slope angle grinder, about 100mm wide, and then along the slope to outside polished 150mm, steel cord conveyor belt to remove the original surface and roughened. 120 # gasoline with polished surface of the wire and clean. Laying of steel cord conveyor belt and lap steel heating plate below the surface of the first layer of clear plastic film, and then laying a layer of plastic material, so that rubber match with both ends of the connector ramp. Then press the required good lap steel, brushing glue, glue brushing to ensure uniform uniform. Then covered with a plastic material, the same at both ends of the ramp with rubber match, the top layer of plastic film, to complete the laying of steel cord conveyor belt joints and lap steel. Sincere rubber vulcanizing machine for your installation of a summary. Placed under the rack to make ends aligned with the centerline of the rack steel cord conveyor centerline alignment. Then place the pressure plate and the lower platen vulcanizing pass board, vulcanized plate placed its face centerline as a benchmark, and with the steel cord conveyor belt centerline alignment. (2) Subject to the bonding part of steel cord conveyor belt production process is completed by the bonding part of the iron block clamped on both sides. 3 in turn placed on the curing plate, pressure plate, and the heat shield, and finally placed on the rack. Require its face centerline aligned with the centerline of steel cord conveyor belt, fitted bolts and tighten one by one. 4 vulcanizing machine after fastening, respectively, then a good high-pressure hose and plug wires and pressure pump. Summary vulcanized rubber for your sincere Operation 1.'re Ready, make one for each component carefully check to make sure no problem, you can send power to the curing press vulcanization. (2) the set temperature of the heating power of 140 ~ 150 °, curing started when the hydraulic pressure to 1Mpa. 3 When heated to 100 ° vulcanization, to continue pressurized to 1.4Mpa. 4 When the temperature was raised to 140 ~ 145 °, the start for 20 minutes. 5 heat up time after the end of curing. To be naturally cooled to 60 °, demolition equipment, complete sulfur steel cord conveyor belt