How to clean belts

Author:admin　Source:Original　Updated:2013-6-5

ZhongBo Industry and Mining Machinery Co.,Ltd Main Products:

General, heat (temperature), acid, oil, cold, abrasion, flame and other general performance of different cotton canvas (CC), Nylon (NN), polyester (EP) conveyor belts and other large angle flat file sideband tread belt, other special-shaped conveyor belt. And a roller, roller, frame, electric roller conveyors such ancillary products. Drive pulley; bend pulley; electric drum; magnetic pulley (magnetic drum); Care roll; stent; lug; tensioner; sweepers; couplings TD75 transportation machinery and ancillary products more than 200 kinds.

Today I come to tell you about how to clean belts.

Steps:

1, turn off the steam valve position adjusting tensioning device according to the pressure.

2, electrical equipment, plastic wrap.

3, the device is connected. The washing machine pick 220v AC.

4, the band performed for large wet. (The purpose of this is to allow better absorption of large with a cleaning solution, cleaning cleaner.)

5, the cleaning solution and water ratio of 1:10 blend and mix well.

6, with the punch gun cleaning solution evenly sprayed on the big belt.

Note: a, big band to strengthen border, do not use a big momentum used to avoid hurting big band. b, punch the gun to one sweep, do not repeat the rinse.

7, rinse with water. This time carefully, with such a large cleaning will clean.

Finally Drying:

1, let the machine run slow, then do not heat.

2, adjust the pressure device. (See the water because the big band will shrink, increase the pressure to the big band pulled the original length.)

3, after 90 minutes when the machine is running, improve machine speed, always observe the big belt, not deviation.

With such a large deviation, it can be divided into the following two cases: a, when the big band run right, you can make the first contact with the left side of a large roller. b, when the big time with a run to the right, so that the first contact with the right of the big rollers.

4, a large band after the normal operation, there is a large online trachea rushed dirt, especially in the heating plate dirt, so as not to stick to the big belt.

Cleaning work had been completed. Clean up the site, finishing tools, inspection tools are complete, so as not to delay the next job.

Previous: Industrial Transport

[ list Home ]

Next: Reasons for causing