The mine conveyor general use what type of conveyor belts, Some use requires a look at several aspects:
1 corrugated wall with baseband layers of not less than five, the middle of the high-strength conveyor belt core, special requirements can be added to the steel mesh to enhance lateral rigidity, the baseband should have good longitudinal flexibility and lateral rigidity, tensile strength and wear resistance.
Rubber conveyor belt installation package directly with the supply chain, not on the scene connector.
3 corrugated sidewall conveyor belt and rubber diaphragm baseband secondary vulcanization bonding at baseband, to ensure that the adhesive strength.
Corrugated wall should have better resistance and anti-tear conveyor belt characteristics and flex resistance, to avoid tensile and compression wall tear.
Diaphragm should be enhanced, should have a certain strength and flexibility, impact resistance, reduce deformation occurs due to partition the force.
Diaphragm with corrugated wall can be requested depending on the circumstances connected with bolts to increase lateral rigidity, and to facilitate the rapid replacement of the layout spacing should be considered corresponding to the crest of the corrugated wall, to prevent the material from the two cracks leave out the formation of the product material and unloading dead ends.
Corrugated wall of the vertical section embedded cord to ensure the flexibility of the corrugated sidewall conveyor belt, and improve the performance of tensile strength.