ZhongBo Industry and Mining Machinery Co.,Ltd main products:
Commoness, heat-resistant (high temperature), acid and alkali resistant, oil resistant, cold resistant, wear resistant, flame retardant cotton canvas for different properties of commonly (CC), nylon (NN) conveyor belt, polyester (EP) flat and large Angle gear sideband, decorative pattern, such as conveyor belt. And the roller, roller, stents, such as electric roller conveyor accessories. The transmission roller; Redirection roller; Electric drum; Magnetic drum magnetic pulley (); Roller; Stent; Lifting lugs; Tensioning device; Sweeper; Coupling, such as TD75 conveyor machinery and more than 200 kinds of products.
Steel roller is easy to rust, no corrosion of acid, alkali, salt and other chemical substances, generally use life as long as 1 to 2 years, wear a high, thus shortens the service life of belt, steel has the value of recycling, steel material roller stolen phenomenon also happen from time to tome. Ceramic roller has the advantages of never rust and corrosion resistance, smooth surface, the wear rate is 0.1%, prolong the service life of the belt, porcelain is no recycling value, reduced the roller theft from happening.
Cylinder helix roller: used to clear the sticky material on the conveyor belt, keep the belt surface clean. Roller stents have trough, trough the heart stents, flat roll, the roll up and down regulation of heart stents, used different materials and different occasions of use. Adjusting roller bracket should be paid attention to in use process, if the tape during no-load always wandering to one side, the side should be wandering the roller holder along the belt running direction forward 1-2 cm, or the other side of the idler bracket (or frame) appropriately heightening. So that we can effectively prevent the belt running deviation phenomenon. So as not to cause leakage material, equipment abnormal wear and damage, reduce productivity, and affect the normal work of the whole equipment such trouble.
Flattering ceramic rollers at both ends with plastic labyrinth seal, oil will not leak, can make the roll shaft running in full sealing condition for a long time. Ceramic surface, the oxide film formation, it is not meet with any matter, any material not reaction. Acid and alkali salt corrode the ceramic roller. Use double section ceramic roller, can reduce the weight of the belt on the roller shape pressure points, could prolong rollers,, and can reduce the belt wear, leather belt is not running and prolong the service life of belt. Can reduce the comprehensive cost of the belt conveyor, reduce the maintenance time. On slope belt strength, small resistance, the best effect. Roller is used for bearing conveyor belt and belt material, ensure stable operation of conveyor belt of the supporting device.
Here is the classification of the roller and its function introduction: buffer roller: installed on the conveyor material down to the bottom of the section, reduce the impact of conveyor belt by extending the service life of the conveyor belt. Grooved roller: used to transport material support; Parallel rollers: parallel roller is used to carry on the conveyor into items, parallel roller is used to return support under the conveyor belt; Self-aligning roller: used to adjust the conveyor belt running deviation, prevent biker, ensure stable operation of conveyor belt; Buffer roller, is installed on the conveyor section below, reduce the impact of conveyor belt by extending the service life of the conveyor belt. Return roller: used to support under the conveyor belt, parallel, V, V.